OBJECT SNAP TOOL IN AUTOCAD

There are three ways to specify an object snap: 







Comments

Post a Comment

Popular posts from this blog

A 27'X52' NORTH FACING G+1 FLOOR PLAN

Image
  A 27'X52' North Facing G+1 Floor Plan , Ground Floor Having 2BHK, With An Attached And a Common Toilet (As Per Client's Need & Strictly Not As Per Vastu ) , A Pooja Room , Parking Area and an External Staircase Up to Roof, First Floor Having 4BHK, Dining , A Common Toilet And a 5' Wide Balcony. CHECK OUT THE ELEVATION OF THE FLOOR PLAN : CHECK OUT THE RENDERED IMAGE :
Read more

HOW TO CALCULATE WEIGHT OF STEEL BARS??

Image
Most Indian TMT bars usually have a standard length of 12m or 40ft. The diameter is variable ranging from 6mm to 40mm depending upon the usage requirements i.e 6mm, 8mm ,10mm, 12mm ,16mm ,20mm ,25mm ,28mm, 30mm, 32mm , 36mm, & 40mm. FORMULA TO CALCULATE WEIGHT OF STEEL BARS: For kg/m : W = D²L/162 For kg/foot : W = D²L/533        Where, D = Diameter of steel bar in mm                     L = Length of steel bar in m                    W = Weight of steel bar in kg If we put 1m length for each diameter of steel bar in the formula then we will get the unit weight. For kg/m : W = D²L/162 6mm Φ bar = 6²*1/162 = 0.222kg/m 8mm Φ bar = 8²*1/162 = 0.395kg/m 10mm Φ bar = 10²*1/162 = 0.617kg/m 12mm Φ bar = 12²*1/162 = 0.89kg/m 16mm Φ bar = 16²*1/162 = 1.58kg/m 20mm Φ bar = 20²*1/162 = 2.47kg/m 25mm Φ bar = 25²*1/162 = 3.86kg/m 32mm Φ bar = 25²*1/162 = 6.32kg/m For kg/foot : ...
Read more

AutoCAD: Manage Layers with the LAYWALK command

Image
LAYWALK is a command that allows us to handle layers. You can access it by going to Home tab> Layers panel (expanded)> Layer Walk. or you can just type LAYWALK in the command line. It opens a dialog where we can see all the layers listed. The objects on the highlighted layers will be shown on the screen. In case we have a lot of layers we can use the filter bar to only show the ones we want. By entering c*, I can display only layers starting with the letter “c”. If you select a layer that has no objects on it, you can click the Purge button to purge the layer. Selecting a layer or several layers , you can right-click in the dialog box and choose Inspect to display the information about the layers and the amount of objects contained. We have also the option to "restore on exit" or not. If restore on exit is active, it means that when we close the LAYWALK window, the layer state will go back to how it was before running the command,  However, you can uncheck that check bo...
Read more